Performance
Compressive strength: ≥ 15 MPa (R2) TS EN 12190) Bond created by bonding: ≥ 0.8 MPa (TS EN 1542) Limited shrinkage / expansion: ≥ 0.8 MPa (TS EN 12617 - 4) These values are under laboratory conditions; It was obtained as a result of the experiments carried out at 23 ± 2 ° C and P ± 5 relative humidity. The values given above may differ depending on the surface and ambient conditions.
Application Limits
Pot life of prepared mortar - Pot Life: Maximum 30 minutes
Application thickness: 2 - 20 mm
Applicable floor thickness: Maximum 10 mm (in one layer)
Time to wait for the second coat application: 2 - 3 hours
Time required to open to traffic: Minimum 24 hours
These values are under laboratory conditions; It was obtained as a result of the experiments performed in 23 ± 2 ° C and P ± 5 ° C relative humidity. The values given above may differ depending on the surface and ambient conditions.
Technicial Specifications
a. Chemical Structure: Cement-based, polymer-added repair mortar
b. Dry Density: 1.25 ± 0.1 gr / cm⊃3;
c. Mortar Density: 1.80 ± 0.1 gr / cm⊃3;
D. Grain Size: ≤ 800 µm
to. Color: Gray
Mixing ratio
It is mixed with water in the ratio of -19 of its weight. (4.25 - 4.75 liters of water for 25 kg packaging)
Mixing Equipment
• Low speed electric mixer (400 rpm)
Special tip mixing equipment
Mixing Time
Mixing should be continued with the help of a low-speed mixer so that there is no dry dust and
lumps. Mortar, 2 - 3 min.
After resting, 1 - 2 minutes before application. It should be mixed again for a long time.
Application Equipment
• Steel trowel
• Polishing trowel
• Sponge
Equipment Cleaning
After the application, the mortar on the equipment used should be cleaned with water before it
dries.
Consumption
Recommended consumption amount for 2 mm thickness in 1 m⊃2; It is 3.4 - 3.8 kg.
This value may vary depending on surface and ambient conditions.
Packaging
MegaTamir İ; It is presented as a total of 54 bags (1350 kg) in craft bags of 25 kg net,
on a pallet measuring 80x100 cm.
Reference Standards
a. Approvals / Standards
• TS EN 1504-3
b. Public Works Look. Pos No.
• Public Works Look. Pos No .: 04.613 / 3A
QUALITY CERTIFICATES
• TS / R2
CE